TREXUS OFFICE FURNITURE
INTRODUCTION PAGE
This page will show you how to :-
fasten the `knock down` fittings used.
fitting and adjustment of door hinges.
fitting of the drawers.
ASSEMBLY FITTINGS
FITTING X1
Locate A over B and using a good quality flat end screwdriver turn
the cam 180° clockwise to lock.
FITTING X2
Insert the pin into the fitting as indicated.
Using a good quality pozidrive screwdriver,
turn the cam 180° clockwise to lock.
HINGE ASSEMBLY
Hinge fitting 1
If the hinge is received in the closed position, use a small screwdriver to open the securing plate
Hinge fitting 2
Fit the door to the hinge and snap the securing plate shut to secure.
Hinge fitting 3
Screw the hinge plates to the carcass fit the hinge mechanism as shown.
Hinge fitting 4
Use the hinge plate to adjust the up and down
Hinge fitting 5
Use this adjustment to align the closed door to the carcass.
Hinge fitting 6
Use this adjustment to align the closed doors
DRAWER ASSEMBLY
Remove the handles from the packet. Use 2 10 x 8
flange screws from the inside to secure to drawer
front.
Pull forward the drawer runners and place the drawer
between as shown.
Align the drawer holes with the threaded holes in the
runner.
Using M4 x 9 screws per drawer, secure to the runner
from the inside.
