TREXUS OFFICE FURNITURE

TOOLS REQUIRED: GOOD QUALITY FLAT SCREW DRIVER,

No 2 POZIDRIVE SCREWDRIVER

You should have: 1 x top pack, 2 x pedestals, 1 x return unit kit.

>back<

For information on how to secure the fittings and fit the drawers in this range of furniture, please view the 

`INTRODUCTION PAGE` before commencing.

  Erect the main unit as per the single pedestal desk using the special side panel (A) found in the return unit kit.

  Fit the legs to the tray pedestal side using the 10 x 1¼ screws.

  Fit these panels to the return unit back panel (B) and tighten X1 fittings. Fit the pedestal spar.

  Push together panels (A) & (B) and tighten X1 fittings.

  Fit the main unit top (D) as shown and secure.

  Fit the Return unit top as shown and secure.

  Using 1 - 6 x 2 screw, fasten the return unit support bar to the main unit top as at (F).

  Using 4 – 6 x 5/8 screws, fit the leveling plate (E) towards the rear

  of the return unit top and joining onto the main unit top.

  Fit the drawers to complete.