TREXUS OFFICE FURNITURE

PART 1

TOOLS REQUIRED: 1 x Good quality pozidrive screwdriver

1 x Good quality flat end screwdriver

1 x Hammer (for pedestal fittings)

1 x Allen key (provided)

>back<

For information on how to secure the fittings and fit the drawers in this range of furniture, please view the 

`INTRODUCTION PAGE` before commencing.

 CANTILEVER END FRAMES BOX CONTAINS :

 1 x Cantilever end frame,

 1 x Screw pack.

Screw pack contents      

 LEG FRAME PREPARATION

 (l/h frame demonstrated)

 Screw in the fittings as shown to both end frames.

PANEL END FITTING INSTRUCTIONS

Top pack box contains: 1 x Cantilever top, 1 x Steel support bar, 1 x Cantilever modesty panel

 MODESTY PANEL PREPARATION

 Push the mini-fix fittings into the pre-drilled holes

 in the back panel as shown with the arrow on the fitting

 pointing towards the outside edges of the panel.

 DESK FRAME ASSEMBLY

 Fit the two end frames to the back panel as shown

 and tighten all the fittings Nos 1118.

  Using the two allen bolts No 1116 insert through

 the end frames, locate the thread in the bar and

 tighten using the allen key No 1102.

 The countersink in the bar should face downwards.

IF PEDESTALS ARE TO BE FITTED TO THE UNIT, THEN PLEASE REFER TO THE CANTILEVER PEDESTAL FITTING INSTRUCTIONS PAGE, IF NOT THEN PLEASE PROCEED TO PART 2