TREXUS OFFICE FURNITURE

CANTILEVER RADIAL DESK ASSEMBLY INSTRUCTIONS

PART 1

TOOLS REQUIRED:  1 x Good quality pozidrive screwdriver

1 x Good quality flat end screwdriver

1 x Hammer (for pedestal fittings)

1 x Allen key (provided)

>back<

For information on how to secure the fittings and fit the drawers in this range of furniture, please view the 

`INTRODUCTION PAGE` before commencing.

BOX CONTAINS : 

1 x Cantilever end frame,

1 x Screw pack

 Screw pack contents

 CANTILEVER FRAME PREPARATION

 (l/h frame demonstrated)

 Screw in fittings as shown to both end frames

PANEL END FITTING INSTRUCTIONS

  Back panel box contains box contains:

2 x modesty panels

1 x Corner leg

1 x Support bar

1 x Short support bar

1 x Screw pack

 CORNER LEG PREPARATION

 Screw the pins 1117 tightly into the leg

 Screw in the adjustable foot

 BACK PANEL PREPARATION

 Push the four mini fix housings No 1118  into the

 pre-drilled holes in the back panel as shown with

 the arrows on the fittings pointing to the outside

 edges of the panel.