TREXUS OFFICE FURNITURE

>back<

For information on how to secure the fittings and fit the drawers in this range of furniture, please view the 

`INTRODUCTION PAGE` before commencing.

 Fit the long modesty panel ‘A’ to the largest end frame

 and tighten the housings No 1118.

 Raise the other end of this panel, fit the corner leg and

 secure.

 Repeat this process using the short modesty panel and

 the smaller end frame.

 Using the bolts No 1116 fix the support bar as shown,

 the 8mm hole being towards the back panel not the

 frame and tighten using the allen key No 1112 provided.

 Ensure that the countersunk holes in the bar are facing

 downwards at this point.

 Fit the short support bar as shown using the 2 allen

 bolts No 1116 (countersink facing downwards).

If pedestals are to be fitted then please refer to the 

CANTILEVER PEDESTAL FITTING page 

 Manoeuvre the round fittings in the top over the pegs

 in the back panels, lay flat and then tighten the

 X2 fitting.

  If a pedestal is to be fitted then do this before

  screwing down the top 

  Using the screws No 1235 secure the support bars

  to the desk tops.