CANTILEVER TABLE END FRAMES
End frame box contains:
2 x Cantilever table end frame
1 x Screw pack see contents
Screw pack contents
TABLE END FRAME PREPARATION
Screw in the fittings as shown to both end frames.
|
TREXUS OFFICE FURNITURE |
|
CANTILEVER TABLE ASSEMBLY INSTRUCTIONS TOOLS REQUIRED: 1 x Good quality pozidrive screwdriver 1 x Good quality flat end screwdriver 1 x Allen key (provided) |
|
For information on how to secure the fittings and fit the drawers in this range of furniture, please view the `INTRODUCTION PAGE` before commencing. |
|
CANTILEVER TABLE END FRAMES End frame box contains: 2 x Cantilever table end frame 1 x Screw pack see contents
|
Screw pack contents |
|
TABLE END FRAME PREPARATION Screw in the fittings as shown to both end frames.
|
|
|
TABLE TOP PACK Top pack box contains: 1 x Cantilever table top, 1 x Modesty panel, 1 x Support bar |
|
BACK PANEL PREPARATION Push the four mini fix housings No 1118, into the pre-drilled holes in the modesty panel .
|
|
|
ASSEMBLY 1 Fit the modesty panel to the end frames as shown and tighten all the housings Nos 1118. Using the two allen bolts No 1116 fix the support bars between the end frames and tighten all four bolts using the allen key No 1102 provided (countersink facing downwards).
|
|
|
ASSEMBLY 2 Place the top on a clean flat surface to avoid scratching and invert the completed table structure onto it. Before fastening the support bars to the top with the screws No 1235, ensure that there is approx 25mm overhang at each end of the table.
|
|
